ST-100 Series

Double Sided Seal Tape

Typical Uses

•Field seaming and repair of polyethylene and polypropylene film/panel.
•Adhesion to concrete walls, galvanized aluminum, plywood, oriented strand board, waferboard, and pink foam insulation sheet.
•Sealing between glass, metal, wood and most plastics.
•Applications that require moisture barrier properties.

Encoat’s ST100 seal tapes are coated on both sides with a thick, aggressive, rubber based adhesive system. The ST100 tapes utilizes a cross laminated reinforcement to reduce stretch and increase puncture resistance. These tapes are designed to perform in applications that require very aggressive, non-hardening sealing properties on porous, low energy, cold, and damp surfaces.

Nominal Test Values

Reinforcement
Adhesive
Tape Color
Tape Thickness
Adhesion to Stainless Steel PSTC 101
Adhesion to Polyethylene PSTC 101
Adhesion to Concrete Block PSTC 101
WVTR (grams/100in² x 24hrs) ASTM D3833
WTR (grams/100in² x 24hrs) ASTM D3816
Typical Service Temperature
Min. Application Temp

Standard Shelf Life: 36 months from date of manufacture when stored under recommended storage conditions shown above.

Recommended Storage Conditions: To maintain best performance, pressure sensitive tapes should be stored at a temperature not to exceed 25C, relative humidity less than 50%, and awat from direct sources of heat and sunlight.

Adhesive Tapes and Cast Films

1-630-636-6722

www.encoattech.com

The above information is for guidance only and does not represent a guarantee of analysis. It is the ultimate responsability of the end user to evaluate and ensure this product meets any performance requirements fo a specific application.

ST-113

Charcoal
23 mils
180 oz/in
115 oz/in
140 oz/in
<0.25
<0.10
-10°F to 165°F
40°F

ST-117

ST-123

Cross Laminated Polyethylene
Synthetic Rubber (Butyl Rubber alternative)

Charcoal
13 mils
150 oz/in
90 oz/in
100 oz/in
<0.25
<0.10
-10°F to 165°F
40°F

Charcoal
17 mils
160 oz/in
100 oz/in
130 oz/in
<0.25
<0.10
-10°F to 165°F
40°F

AKA: